Dbx DriveRack PA2 Bedienungshandbuch Seite 17
- Seite / 70
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
13
®
The Home Screens
The Home screen is the first screen which appears in the LCD display after the DriveRack PA2 fully initializes (this is also
referred to as “Home mode”). There are four Home screens to choose from, providing the instant visual feedback you need,
when you need it. All Home screens will display the currently loaded preset number and name, so you always know which
preset is currently loaded. To toggle between Home screens, simply press the DATA WHEEL from Home mode. Below is a
description of each available Home screen.
Configuration Home Screen
This is the default Home screen. This screen shows the configuration and signal flow
of the currently loaded preset. The far left of the screen indicates input configuration.
The far right of the screen indicates output configuration. All the blocks in-between
represent the processing modules.
Preset 1
1
RTA
USER
L
LH
RH
LM
RM
LL
RL
R
MIC
Configuration Home Screen
Dynamics Meter Home Screen
This Home screen shows dynamic processing activity in the input compressor and
output limiter modules. The meters on the left of this screen show threshold activity. The
Preset 1
1
EDIT
COMPRESSOR
HIGH LIMITER
MID LIMITER
LOW LIMITER
30 12 5 0
O
O
O
O
icon indicates the signal is below threshold and no dynamics processing is occurring.
The
Preset 1
1
EDIT
COMPRESSOR
HIGH LIMITER
MID LIMITER
LOW LIMITER
30 12 5 0
O
O
O
O
icon indicates that the signal level is within the “OverEasy™” region and some
minor compression or limiting is beginning to occur (this icon will only light if the
dynamics processor is configured for “OverEasy” operation). The
Preset 1
1
EDIT
COMPRESSOR
HIGH LIMITER
MID LIMITER
LOW LIMITER
30 12 5 0
O
O
O
O
icon indicates that
the signal is over threshold and full compression or limiting is occurring. The meters on
the right show how much gain reduction is occurring in each processing module.
Preset 1
1
EDIT
COMPRESSOR
HIGH LIMITER
MID LIMITER
LOW LIMITER
30 12 5 0
O
O
O
O
Dynamics Meter Home Screen
RTA Home Screen
This Home screen provides quick access to the Real-Time Analyzer. When the optional
dbx RTA-M measurement microphone is connected to the RTA Mic Input, this RTA can
be used for manually fine-tuning and troubleshooting the system.
Preset 1
1
EDIT
RTA
RTA Home Screen
System Info Home Screen
This Home screen shows the currently installed firmware version and the IP address
assigned to the PA2.
Preset 1
Version: 1.1.3.0
IP: 192.168.0.2
1
USER
System Info Home Screen
NOTE: After a power cycle, the DriveRack PA2 will return to the Home screen selected before the unit was powered
down.
NOTE: The TIME OUT feature in the Utility menu will determine if the DriveRack PA2 will return to the Home screen
after a period of inactivity and how long it will wait before timing out. See ‘Utility’ on page 46 for further information on
the TIME OUT feature.
- Owner’s Manual 1
- U.K. MAINS PLUG WARNING 2
- WARNING FOR YOUR PROTECTION 2
- READ THE FOLLOWING: 2
- IMPORTANT SAFETY INSTRUCTIONS 2
- DECLARATION OF CONFORMITY 3
- SAFETY INSTRUCTIONS 3
- Warranty 4
- Table of Contents 5
- Overview 6
- Features 7
- Front Panel 8
- 9. INPUT Meters 9
- 10. CLIP LEDs 9
- 11. OUTPUT Meters 9
- 12. TH (THRESHOLD) Meters 9
- 13. MUTE Buttons 9
- Rear Panel 10
- 6. Input Switches 11
- Installation Recommendations 12
- Making Connections 12
- Applying Power 14
- Getting Started 15
- Operating Modes Explained 16
- The Home Screens 17
- Using The Wizards 18
- AutoEQ Mic Position 2 19
- Amp clips 12 dB 24
- Both amp and mixer 24
- Operating The DriveRack PA2 28
- Managing Presets 29
- Graphic EQ (GEQ) 31
- BAND(1-8) Q [0.1 - 15.909] 34
- LIVE LIFT [ON, OFF] 38
- LIFT AFTER [5S - 60M] 38
- SELECTED FILTER [1 - 12] 38
- -40 -24 -12 -6 0 39
- 30 12 5 0 41
- GAIN [-20 dBu to +20 dBu] 42
- OVEREASY [OFF, 1-10] 42
- DELAY [ON, OFF] 44
- Crossover (XOVER) 45
- POLARITY [NORMAL, INVERTED] 46
- LIMITER [ON, OFF] 47
- Power-Up Functions 51
- System Lockout 52
- Factory Reset 53
- Soft Reset 53
- Application Guide 54
- 120V 50/60Hz 55
- 3-Way Application 58
- Preset List 59
- Device Requirements 60
- Networking 61
- 5� Software Firewall 62
- Technical Information 63
- DSP Block Diagram 64
- Cable Diagrams 65
- Audio Cable Diagrams 66
- Dimensions 67
- Specifications 68
- Additional Resources 69
Verwandte Produkte und Handbücher für Musikausrüstung Dbx DriveRack PA2
(48 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 2.258 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern